Glass door installation method

[China Glass Net] The glass door is a special type of door leaf. First of all, its thickness is not enough to be a solid door, and it is not a special-shaped door. In fact, it is a special form of door leaf. The characteristics of the glass door are determined by the characteristics of the glass itself. For example, when tempered transparent glass is used, the door leaf has a transparent function, and when frosted glass is used, it has a semi-transparent function. It is also an event that results from this.

Glass doors are common in interior doors. For example, most of the doors in the bathroom or kitchen use glass doors. The installation of glass doors is different from the general wooden door installation.

1: Positioning and paying line: The glass door is composed of fixed glass and movable glass door leaf, and the positioning of the line is unified.

2: Limiting groove at the top of the mounting frame: the width of the limiting slot should be larger than the thickness of the glass by 2-4mm, and the depth of the groove is 10-20mm. When installing, firstly, the two metal decorative board edges are drawn from the drawn line, and then the edge is drawn. Install the limit slot at the top of the door frame.

3: Install the wooden bottom of the metal veneer: first fix the square wood on the ground, then stick the metal veneer to the wood with the multifunctional glue. The square wood can be directly nailed to the pre-buried wooden brick, or by expanding The method of bolting is fixed.

4: Install the vertical door frame: connect the center line of the bullet to the door frame, then use the plywood to determine the shape and position of the door frame column, and then outsource the metal decorative surface.

5: Install the glass: Use a glass suction machine to suck the thick glass, then hold the suction cup and lift the thick glass plate by 2-3 people to move to the installation position.

6: Fixing glass: Two small square wooden strips on the bottom and side of the wooden block are placed on the middle door, the square wood strip is about 4mm away from the glass plate surface, and then the multi-purpose glue is applied on the square wooden strip. Stick the veneered metal on the square strip.

7: Injection glass seal: In the gap between the top limit groove and the bottom bracket, and the gap between the thick glass and the frame column, the glass seal is injected.

8: Docking between glass: When the fixed part of the glass door needs to be spliced ​​by the oversize, the seam should have a width of 2-3mm, and the edge of the glass should be chamfered.

9: Dynamic glass door installation: Before the door leaf is installed, the grounding spring and the positioning pin on the top surface of the door frame should be positioned and installed. The two must be coaxial. Check the vertical line during installation to ensure the center of the ground spring shaft and the positioning pin. The lines are on the same line.

10: Install the glass door leaf upper and lower door clamps: Install the upper and lower metal door clips on the upper and lower ends of the glass door, and measure the door height.

Tencel Rayon Fabric

Tencel Rayon Fabric,Tencel Fabric,Custom Tencel Fabric,Rayon Fabric

Shaoxing Anze Textile Co.,Ltd , https://www.anzefabric.com